Chassis

The Inline Chassis Kit includes front and rear chassis halves, two 2” long axles, two rear axle bushings, a guide flag plate, guide flag, lead wires, four axle shims, and eight chassis screws.

This chassis is made to accept the GM 9330, GM 14955, and FF030 motors.

The fold lines are cut to help ensure even and accurate folds.

The included axle diameter choices are .085" or .094" and are by the request of the customer.

The adjustment range of the chassis, using the forward most front axle holes, is from 2-1/4" to 3-1/4". The chassis can be made to adjust even shorter by trimming the ends of the chassis halves.

The Rolling Chassis Kit consists of one of the above kits plus four aluminum wheels, four tires, a motor, a pinion gear, a crown gear (Inline only), .094 axles, and a hex key.

The customer must specify the following:

                    Wheel diameter(s)
                    Wheel widths
                    (two front, two rear)
                    Tire type(s)
                    (two front, two rear)
                    Motor type (Inline only)
                    (GM 9330 or 14955)
                    Pinion Gear Teeth
                    Crown Gear Teeth
                    (Inline Kit only)

The Sidewinder Chassis Kit includes front and rear chassis halves, two .094" x 2” long axles, two rear axle bushings, a guide flag plate, guide flag, lead wires, four axle shims, a spur gear, and eight chassis screws.

This chassis is made to accept the Radio Shack Micro Super High Speed Motors.

The fold lines are cut to help ensure even and accurate folds.

The included spur gear choices are 34 tooth and 36 tooth and are to be specified by the customer.

The adjustment range of the chassis, using the forward most front axle holes, is from 2-1/4" to 3-1/4". The chassis can be made to adjust even shorter by trimming the ends of the chassis halves.